Documents
Please see the Environmental Documents page for program-specific environmental documents and work instructions.
Fort Novosel conducts activities involving a wide array
of hazardous substances, including, but not limited to, oils, fuels, solvents,
paints, and various wastes. If improperly managed, these operations
could result in releases to the environment. In order to minimize
potential adverse environmental impacts, Fort Novosel has
implemented operational controls relating to these activities. These
controls include operational practices within individual organizations, as well
as planning for the installation as a whole. Each person has a
responsibility to limit the risk of spills and releases while completing their activities in support of the overall mission.
Spill Prevention and Response Plans
Fort Novosel has implemented several management documents
which address spill prevention and response activities. These plans
address spill prevention measures for oil storage sites, oil transfer sites,
and hazardous substance storage areas located within the Fort Novosel
Reservation boundaries, as well as all other off-post properties managed
by Fort Novosel. The following plans are used at Fort Novosel:
- Installation Spill Contingency Plan (ISCP)
- Spill Prevention Control and Countermeasures Plan (SPCC Plan)
- Stormwater Pollution Prevention Plan (SWPPP)
The ISCP has been recently revised and is
available at the link posted above. The revised ISCP incorporates revised
requirements from 40 CFR 112 and AR 200-1 as well as information in the
recently revised SPCC Plan.
Mandatory Spill Training for Individual Organizations
At least once per year, all organizations (including contractors)
must provide initial or update training for all employees who handle or use
hazardous materials, hazardous waste, and/or POL of any type in quantities equal to or greater
than 1 quart at a time (this requirement does not include refueling a ground
vehicle at a fuel pump). New employees must not be allowed to perform any
operations involving hazardous materials, hazardous waste, or POL without
direct supervision until they receive training. Training will, at a minimum,
cover the following subjects:
- Installation Spill Contingency Plan (ISCP) requirements
- General requirements of the SPCC Plan
- Container-specific requirements of the SPCC Plan applicable to
their assignments
This training is required to meet federal and state regulations
and is very important.
Spill
Response and Reporting Actions
Any person discovering a spill or release of oil or hazardous
substances must immediately report the incident to his/her supervisor. The
supervisor will determine if the spill is minor and should be cleaned up
without further notification, or if further notification is required.
If a supervisor cannot be quickly notified or if a major spill
threatens personnel safety or may reach surface waters, storm drains, or
sanitary sewer drains, the Fire and Emergency Services Division (Directorate of
Public Safety) must be notified immediately by calling 911.
The employee or supervisor reporting a spill to the Fire and
Emergency Services Division should provide the following information to the
fullest extent known:
- Location, time, and type of incident (spill, fire, injury, etc)
- Name and quantity of spilled material, and the rate of release (an
estimate is OK if not known)
- Provide a safety data sheet for spilled material if readily
available; can be faxed to the Fire and Emergency Services Division (if it can
be done quickly) or provided at the time of their arrival to the scene
- Direction of the spill, vapor, or smoke release
- Fire and/or explosion possibility
- Coverage area of spill, and intensity of any fire or explosion (if
applicable)
- The extent of injuries (if any)
As part of the existing notification procedures, the Fire and
Emergency Services Division will always notify DPW-ENRD so there is no need for
the reporter of the spill to place a second call to the
environmental office once the Fire and Emergency Services Division has
been notified.
When the Fire and Emergency Services Division has determined that
there is no longer a threat to life or property, DPW-ENRD will serve as the
on-scene coordinator and will determine if the spill is reportable to others as
required by the ISCP. Cleanup assistance and remediation of the site (if
necessary) will be provided by the installation maintenance support contractor.
The unit or organization responsible for the spill will be billed later for any
cleanup or remediation expenses.
The organization responsible for the spill or release must
complete a written spill report by utilizing USAACE Form 2718, Spill
Notification Report. The form should be faxed to DPW-ENRD at (334) 255-2058
within 5 days of the incident. A link for the referenced report is available on
this page.